Make a pocket milling and use
an appropriate tool. DXF files are
available on demand
The excess wood should not be
more than 2.0 - 3.0 mm thick
Carefully clean the routing and
sand the pocket milling in the next step
Sand the surface of the milling
Use a wood primer for best adhesive properties, prior to that remove all dust etc.
Remove the protective film from the double-sided tape*
Insert the speaker carefully
Don‘t use to much force when
pressing down, you must not press down the exciter drivers!
Speaker is ready for cable connection. You can use a cerasonar backbox as option (e.g. 9062 backbox).
Attached the bracket on rear of the speaker. This serves as an additional mechanical safety measure.
Now screw the bracket, use the pre-drilled holes. Do not overtighten the screws!
Test the speaker now.
OPTIONAL BACKBOX MOUNT:
To install the cerasonar wood installation backbox, an installation groove must be provided in the wooden panel.
OPTIONAL BACKBOX MOUNT: The groove is filled with a suitable adhesive (e.g. Würth Bond + Seal).
OPTIONAL BACKBOX MOUNT: The speaker cables are connected with the correct polarity. The backbox is then pressed into the groove filled with adhesive.