Step 1
Make a pocket milling and use
an appropriate tool. DXF files are
available on demand
Step 2
The excess wood should not be
more than 2.0 - 3.0 mm thick
Step 3
Carefully clean the routing and
sand the pocket milling in the next step
Step 4
Sand the surface of the milling
Step 5
Use a wood primer for best adhesive properties, prior to that remove all dust etc.
Step 6
Remove the protective film from the double-sided tape*
Step 7
Insert the speaker carefully
Step 8
Don‘t use to much force when
pressing down, you must not press down the exciter drivers!
Step 9
Speaker is ready for cable connection. You can use a cerasonar backbox as option (e.g. 9062 backbox), this will enhance the sound quality if you do not have a comparment
Step 10
Attached the bracket on rear of the speaker. This serves as an additional mechanical safety measure.
Step 11
Now screw the bracket, use the pre-drilled holes. Do not overtighten the screws!